Skip to content

Input sensitivity jumpers

The miniDSP 2x4 HD can be set for an analog input sensitivity of 2 Vrms or 4 Vrms. The default as shipped is 2 Vrms. The 4 Vrms setting is useful if a source device produces more than 2 Vrms.

Info

The 4 Vrms setting reduces the input sensitivity. Overall system gain is reduced by 6 dB.

Changing the setting requires that the board be removed from the chassis. Remove two screws from the output side and two screws from the input side as shown here:

Remove 2x4 HD from chassis

The board can then be pulled out from the output side. Change the position of the jumpers as shown here:

miniDSP 2x4 HD input sensitivity jumpers

Warn

Be sure to position the jumpers correctly on the pins. You may need to use a small pair of pliers to do this.

Slide the board back into the chassis and refasten the screws. (If you didn't take note of which screw came from where, the "pointy" screw goes between the input RCA jacks.)