Signal routing¶
Overview¶
Each input channel can be sent, or routed, to any number of output channels. This is accomplished with the routing buttons at the top of the output channel strips:
In addition to routing, the miniDSP SHD Power supports mixing, where input channels can be mixed at different levels to a single output channel. The complete set of routing controls along the top of the output channel strips is therefore also called the "matrix mixer."
Basic routing¶
To route an input channel to an output channel, click on the input channel's name. When routed, the button is green:
Note: if the input channel has been renamed, it's name will appear instead of e.g. "Input 1".
Mixing¶
To mix both input channels to an output, select both of them:
By default, each input channel is mixed at "full strength" – that is, without any attenuation, as indicated by the "0 dB" label. To mix at different levels, click on the level button and either use the slider or enter the desired value directly. The gain of the signal being mixed can be set to a value between -72 and +12 dB.
In this example, both channels are mixed at half level (-6 dB):
Routing examples¶
This section illustrates a few examples of signal routing. The input and output channels have been renamed by typing in the labels at the top of the channel strips. We recommend you do the same to help avoid errors.
Subwoofer integration¶
The diagram below illustrates the connections of the miniDSP SHD Power to a stereo pair of speakers and a single subwoofer. The subwoofer is connected to output 3. In the diagram, it's a powered subwoofer. (Never connect output 3 or output 4 directly to a subwoofer driver or speaker.)
The routing for this system is:
The left and right inputs are sent to outputs 1 and 2. Both inputs are summed and sent to output 3. Outputs 1 and 2 will usually have a high pass crossover filter to remove the sub frequencies, and output 3 will have a low pass crossover filter.