Skip to content

Front and rear panels

Basic operation

The front panel and rotary encoder provide access to the key features of the miniDSP SHD Power. These can also be accessed with a remote control.

miniDSP SHD Power front panel with OLED display

  • To change the volume, rotate the encoder. The volume changes in 0.5 dB steps. Minimum volume is -127.5 dB and maximum volume is 0.0 dB.

  • To select a preset, press the encoder knob once, then rotate until the desired preset number is displayed. Either press the encoder knob again or wait for a second. The display will show "Pls wait..." while the new preset is being loaded, and then return to normal.

  • To select an input source, press the encoder knob twice, then rotate the encoder until the desired input source is displayed. Either press the encoder knob or wait for a second and the display will return to normal with the new input selected.

  • To turn Dirac Live filtering on and off, press the encoder knob three times, then rotate the encoder knob until the desired selection (on or off) is displayed. Either press the encoder knob or wait for a second and the display will return to normal with the Dirac Live status:

miniDSP SHD Power: turn Dirac Live on and off

  • To mute output, press and hold the encoder knob. When the display changes to show "Mute?," release the knob. To unmute, repeat this procedure.

miniDSP SHD Power: mute and unmute

  • To put the SHD Power into standby, press and hold the encoder knob. When the display changes to show "Standby?," release the knob. To take it out of standby, press the encoder knob.

Tip

All these operations can also be performed with the remote control.

Rear panel connnections

Warning

Apply power to the miniDSP SHD Power only after all input and output connections have been made.

Connections on the rear panel of the miniDSP SHD Power

  1. Digital outputs. Connect downstream digital equipment with AES-EBU cables. These outputs each carry a stereo signal. The data format is 24-bit 96 kHz. Connected equipment must therefore be able to accept a 24-bit 96 kHz input signal.

  2. Subwoofer outputs. Connect one or two powered subwoofers here.

  3. Digital inputs. Connect digital sources using optical (TOSLINK SPDIF), coax (RCA SPDIF), or AES/EBU (XLR). Sample rates from 32 up to 216 kHz are supported. The three digital inputs can be individually selected with the front panel encoder or the remote control.

  4. USB port for control and audio streaming. Connect to an available USB port on your computer.

  5. Host port for USB music stick or Wi-Fi adapter.

  6. Ethernet port for network music streaming.

  7. Power inlet. Connect a standard IEC C13 cable here. The mains supply voltage can be in the range 95 to 240 VAC, 50 to 60 Hz.

  8. Fuse holder. If the fuse needs replacing, remove the power cable. Then use a small flat-bladed screwdriver to lever out the fuse and fuse holder. Replace the fuse with a 250V rated 8A fuse and push the fuse holder firmly back in.

  9. Power switch. Turns main power to the SHD Power on and off.

  10. Speaker outputs. Connect directly to speakers using conventional speaker cables with spade or banana terminations.