Power and control

This page describes how to connect the miniDSP 2x4 HD to power, and the connections needed to configure it using Device Console.

Power

The supplied 12 VDC power supply includes a set of interchangeable power pins (for USA, UK, Europe and Australia). Fit the correct pins for your country. Connect the DC plug to the 12 VDC power socket.

Apply power to the 2x4 HD only after all input and output connections have been made. When applying or removing power, the following sequence is recommended:

• On: Power on line-level equipment, including the 2x4 HD, then turn on power amplification.

• Off: Turn power amplification off, then power off line-level equipment, including the 2x4 HD.

Configuration over USB

The USB port is used to configure the 2x4 HD with Device Console. Usually, this is connected directly: use the supplied cable to connect a free USB 2.0 port of your computer to the USB port (Type Mini-USB) on the 2x4 HD input panel.

If longer cable lengths are required, an active USB extension cable can be used.

Configuration over the network

For configuration using Device Console, an optional miniDSP Wi-DG Wi-Fi to USB bridge can be used. This enables configuration over the Wi-Fi network, without the USB cable. The figure below shows a typical connection example.